Tuesday, June 11, 2013

First cut of draft Source for standalone regulator posted

Today I placed up the 1st cut of Source Code for the stand-alone regulator project.  version 0.0.1

This version is mostly complete, but has only had limited testing on a stand-alone Arduino UNO card - there is no regulator hardware available yet.  The source can be found under the SOURCE tab above, looking in the standalone regulator directory.

I also posted a .wrd file that does some initial documentation of the regulator, and in particular the ASCII strings in and out to be used to monitor status as well as optionally change configuration parameters.  Over time this document will be expanded.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.